Article ID: 000080239 Content Type: Error Messages Last Reviewed: 09/11/2012

Warning: On-chip termination control block "name" parameter enable_parallel_termination changed to true

Environment

    Quartus® II Subscription Edition
BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

You may see this warning when you compile a design using DDR3 SDRAM Controller with UniPhy in Quartus® II software version 11.1SP1 or earlier. This warning can safely be ignored since parallel termination is expected.

The warning is scheduled to be fixed in a future version of Quartus II software.

Related Products

This article applies to 1 products

Intel® Programmable Devices

1

Need more help?

Contact support

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.