Article ID: 000077394 Content Type: Troubleshooting Last Reviewed: 11/28/2024

When using a simplex RX or TX channel in the Stratix®10 L- or H-Tile device, do I need to assign the preserve unused channel QSF to the unused RX/TX of the simplex channel?

Environment

  • Intel® Quartus® Prime Pro Edition
  • L-Tile H-Tile Transceiver Native PHY Intel® Stratix® 10 FPGA IP
    • BUILT IN - ARTICLE INTRO SECOND COMPONENT

    Critical Issue

    Description

    If you intend to use the simplex TX/RX channels as duplex channels in future, you need to assign the preserve unused channel QSF to the unused RX/TX channel.

    Resolution

    There is no resolution to this subject. 
     

    Related Products

    This article applies to 4 products

    Intel® Stratix® 10 GX FPGA
    Intel® Stratix® 10 SX SoC FPGA
    Intel® Stratix® 10 MX FPGA
    Intel® Stratix® 10 TX FPGA

    Need more help?

    Contact support

    Disclaimer

    1

    All postings and use of the content on this site are subject to Intel.com Terms of Use.