Article ID: 000077173 Content Type: Troubleshooting Last Reviewed: 11/25/2013

Migrating UniPHY IP from 13.0 SP1 DP5 to 13.1 Resets GUI to Default Values

Environment

  • Quartus® II Subscription Edition
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT

    Critical Issue

    Description

    This problem affects DDR2, DDR3, LPDDR2, QDR II, RLDRAM II, and RLDRAM 3 UniPHY-based products.

    When a top-level EMIF wrapper generated in the Quartus II software version 13.0 SP1 DP5 is opened in version 13.1, the parameter editor GUI is reset to its default values and your design-specific parameters are lost.

    Resolution

    The workaround for this issue is to remove the ENABLE_DELAY_CHAIN_WRITE parameter from the top-level wrapper file. To do this, open the top-level wrapper file in an editor and remove the following line:

    -- Retrieval info: <generic name="ENABLE_DELAY_CHAIN_WRITE" value="false" />

    This issue will be fixed in a future release.

    Related Products

    This article applies to 1 products

    Arria® V FPGAs and SoC FPGAs