Article ID: 000074888 Content Type: Troubleshooting Last Reviewed: 12/04/2017

Intel® Cyclone® 10 LP Core Fabric and General Purpose I/Os Handbook: Known Issue

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

Issue 516862: Chapter 6 Configuration and Remote System Upgrades, Version 2017.05.08

Figure 101. Programming Serial Configuration Devices In-System Using the JTAG Interface

25k ohm is connected to DATA pin of Serial Configuration Device in the figure.  But this is incorrect.  The correct resistor value is 25 ohm. 

Related Products

This article applies to 1 products

Intel® Cyclone® 10 LP FPGA

Disclaimer

1

All postings and use of the content on this site are subject to Intel.com Terms of Use.