Mobile Intel® Celeron® Processors Installation Guide

Last Reviewed: 19-May-2017
Article ID: 000008240

The mobile Intel® Celeron® Processor is available as a boxed processor for laptop computers in the micro-PGA2 form factor. Intel recommends the processor should be installed by a computer professional since this electronic device may cause serious damage to the installer, system, and processor if installed improperly.

Note Before attempting to install a new processor, carefully review the documentation that came with your system and make sure that you will not be voiding your warranty by opening the computer or replacing your processor.


  1. Make sure that your system can accommodate the mobile Intel Celeron Processor that you want to install. Check for motherboard, BIOS, and thermal compatibility by using the manufacturer's documentation for the laptop computer, or by contacting the vendor if necessary.
  2. Obtain access to your processor socket as described in the documentation for your system.
  3. If the cooling solution prevents you from accessing the processor socket, you may need to remove it. Instructions on how to remove your cooling solution should be provided in the documentation that came with the system.
  4. To uninstall the current processor, use a screwdriver to disengage (open) the socket actuator, as shown in Figure 1 below. (The most commonly used sockets are Molex* or FoxConn* sockets, so they are used in the illustrations below.) The socket actuator should open after only a half turn or so, and you should then be able to remove the processor with your fingers.

Figure 1: Disengaging the Socket Actuator

Disengaging the Socket Actuator

  1. Using the method shown in Figure 2, place the new processor into the socket. Align the processor's pin A1 with the arrow on the micro-PGA2 socket. The pin A1 of the processor is identified with a embroidered corner and the pin A1 of the socket is identified with a small arrow. If the processor does not drop completely into the socket, turn the actuator until the processor drops completely in.
    Note You should not have to press down on the processor.

Figure 2: Aligning the Processor in the Socket

Aligning the Processor in the Socket

  1. While gently holding the processor down with your finger, secure the processor in the socket by closing the socket actuator with a screwdriver (See Figure 1).
  2. Reattach the cooling system, and reassemble the system per documentation that came with the system.

It is important to keep in mind:

  • Your system may require special voltage and speed settings for the new processor to function correctly. Some systems are auto configuring, while other are set with jumpers, dip switches or the CMOS setup program. Consult your system manufacturer's documentation to determine the correct settings.
  • It is important that you install the cooling system properly per the installation manual. If the laptop or laptop OEM documentation specifies to use a piece of thermal interface material, a new piece must be applied. Since the thermal interface material varies from computer to computer, you must get the material from the laptop or laptop vendor.

This article applies to: