|Note||This information only applies to Windows 7* systems and SSD's with a SATA connector interface. Windows 8*/8.1* and Windows® 10 operating systems block Secure Erase functionality through the Intel® Toolbox on SATA connected SSD's.|
The Intel® SSD Toolbox user guide states that after plugging the SSD data cable in and clicking Refresh, Secure Erase can be started.
If the system BIOS is set to AHCI, the following error can occur: ATA Security is enabled. Secure Erase can't run until security is disabled.
To resolve the issue:
- Make sure you have installed Intel® Rapid Storage Technology (Intel® RST).
- In Windows 7*, click Start, click Run, type "services.msc" and then click Enter.
- Change Intel® Rapid Storage Technology settings from Automatic (delay) to Automatic.
- Restart the system.
- Run Secure Erase on the Intel SSD Toolbox. The refresh rate should be faster when you plug in the SSD.