Article ID: 000074847 Content Type: Product Information & Documentation Last Reviewed: 09/05/2019

How do I configure the Intel® Quartus® Prime Pro software to use an Intel Enpirion® EM22x device as a SmartVID Power Management Controller for Intel Stratix® 10 devices?

Environment

  • Intel® Quartus® Prime Pro Edition
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    Intel® Enpirion® EM2260 / EM22xx parts can be used as Power Management Controllers for SmartVID enabled variants of Intel Stratix® 10 devices. Follow the instructions below to configure the Intel Quartus® Prime Pro software for this use case.

    Resolution

    In the Device and Pin Options dialog box in Intel Quartus Prime Pro Software, under Power management and VID tab select :

    • Bus Speed mode : 100 KHz / 400 KHz
    • Slave Device type : Other
    • PMbus Device X Slave address : Set the PMbus address in hex without the '0x' prefix
    • Voltage Output format : Linear
      • Intel Enpirion devices only support Linear mode
      • If Auto Discovery is selected, set the direct coefficients m/b/r to 0
    • Linear format N : -13
    • Translated voltage value unit : Volts
    • Enable PAGE command : Leave this disabled (Default) 
      • Intel Enpirion devices do not support PAGE command

    Related Products

    This article applies to 1 products

    Intel® Stratix® 10 FPGAs and SoC FPGAs