LNT-30014: Asynchronous Pulse Generators


A pulse generator in a design should not generate pulses in any of the following ways:

  • Creating a wide glitch using a two-input AND , NAND , OR , or NOR gate, where the source for the two gate inputs are the same, but the design inverts the source for one of the gate inputs.
    Figure 1. Asynchronous Pulse Generator Example
  • Using a register where the register output drives the register's own asynchronous reset signal through a delay chain (one or more consecutive nodes that act as a buffer for creating intentional delay).
    Figure 2. Asynchronous Pulse Generator Example

These pulse generators are asynchronous, where the generated pulse width can never be reliably predefined. As a result, the pulse width depends on the circuit delay. For example, the pulse width generated by a pulse generator that uses a 2-input AND gate depends on the relative delays of the path that drives the AND gate directly, and the path that the design inverts before driving the AND gate.


Ensure that any pulse generator generates pulses in a synchronous manner, without violating any of the guidelines in the Description.

Figure 3. Synchronous Pulse Generator.. Ensure that pulse generators generate pulses as shown in the following example recommended pulse generator implemented in a synchronous manner:




Tag Description

Device Family

  • Intel® Arria® 10
  • Intel® Cyclone® 10 GX