ID:176154 Fast PLL <name> drives non-DPA channels with <number> Mbps differential I/O data rate, but the target device <name> can support only <number> Mbps maximum differential I/O data rate for non-DPA channels

CAUSE: The specified fast PLL is not driving dynamic phase alignment (DPA) channels with the specified differential I/O data rate. However, the target device can support only the specified maximum differential I/O data rate for non-DPA channels.

ACTION: Modify the design so that the differential I/O data rate is less than or equal to the specified maximum differential I/O data rate for non-DPA channels of the target device. If you are using SERDES receivers, enable DPA for those channels. If you are using SERDES transmitters, make sure that the external receiver of the data is DPA enabled or configure proper timing budget to it.