ID:14065 WYSIWYG primitive "<name>" uses pterm5 port, but pterm5 port is not supported for non-parallel expander or VCC modes

CAUSE: The specified WYSIWYG primitive uses the pterm5 port, but is also either in non-parallel expander mode (that is, the PEXP_MODE parameter is set to OFF) or in VCC mode (that is, the OPERATION_MODE parameter is set to VCC). The pterm5 port is not supported for non-parallel expander mode or VCC mode. Either the PEXP_MODE parameter must be set to ON or the OPERATION_MODE parameter set to something other than VCC if the pterm5port is used.

ACTION: If you are using an EDA tool, contact the technical support for the EDA tool regarding this message. For further assistance, contact Intel Technical Support by creating a Service Request at www.altera.com/mysupport.