ID:14077 WYSIWYG primitive "<name>" uses fpin fast input port that does not feed register port -- it must feed register port. In addition, WYSIWYG primitive must not use pterm5 and pxor ports, and, if PEXP_MODE parameter is set to OFF, it must not use the pterm0 - pterm4 ports.
CAUSE: The specified WYSIWYG primitive uses a fpin
fast input port, but the fpin
port is not connected to the register port of another WYSIWYG primitive. The WYSIWYG primitive may also be using a pterm5
or pxor
port, which are not supported, or may be in non-parallel expander mode (that is, it may have the PEXP_MODE
parameter set to OFF
) but is using pterm
(pterm0
–pterm4
) ports. The fpin
input port must feed the register port of another WYSIWYG primitive. In addition, the pterm
or pxor
ports must not be used, and either the PEXP_MODE
parameter must be set to ON
, or the pterm
(pterm0
–pterm4
) ports must not be used.
ACTION: If you are using an EDA tool, contact the technical support for the EDA tool regarding this message. For further assistance, contact Intel Technical Support by creating a Service Request at www.altera.com/mysupport.