- If you have not already done so, set up the ModelSim-Intel FPGA
Edition working environment.
- Start the ModelSim software.
- Change to the directory where the ModelSim libraries are located
after they are compiled.
- To create a new work library, type the following command at the
ModelSim prompt:
vlib work
ModelSim compiles the design files to
library work by
default.
- To change the default library, type the following commands at
the ModelSim prompt:
vlib <user defined library>
vmapwork <user defined library>
Note: When
you run the ModelSim software automatically from the
Quartus® Prime software, your work library is
automatically mapped to rtl_work for RTL simulation and gate_work for gate
level simulation. The libraries are created in the
<project directory>\simulation\modelsim directory or
the location you specified in the Output directory box of the Simulation page in theSettings dialog box.
- Before performing a functional or timing simulation, you should
map to libraries and compile design files with the ModelSim-Intel FPGA Edition
software.
To continue the
ModelSim-Intel FPGA Edition flow, you can perform a functional simulation with the
ModelSim-Intel FPGA Edition software, and then you can perform a timing simulation
with the ModelSim-Intel FPGA Edition software.