Weak Pull-Up Resistor logic option
A logic option that enables the weak pull-up resistor when the
device is operating in user mode. This option pulls a
high-impedance bus signal to VCC
. The Weak Pull-Up
Resistor option should not be used at the same time as the
Enable Bus-Hold Circuitry option.
This option must be assigned to a pin or it is ignored.
This option is available for all Intel devices supported by the Quartus® Prime software except MAX3000 and MAX7000AE, and MAX7000S devices
Scripting Information |
Settings:
|
Note: For complete scripting syntax, refer to the
Quartus Settings File Reference
Manual.