List of Messages |
CAUSE: You set the design to use non-default slow timing corner; however,the Fitter does not support non-default slow corner for timing-driven compilation, it will use the default slow corner instead.
ACTION: Avoid using non-default slow temperature settings. Ensure that the Quartus Prime Settings File (.qsf) does not use the non-default MAX_CORE_JUNCTION_TEMP setting. Note: If non-default setting is used, the compilation may have bad timing closure results, as the fitter assumes default corner timing.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.