List of Messages |
CAUSE: The typical causes of being unable to find a specified edge are a typographical error, specifying an illegal edge, specifying a source and a destination that do not have a timing arc between them, or a mismatch between the specified edge type and the edge ID.
ACTION: Check that there was no typographical error. If entering an edge ID as a method of edge specification, check that the edge ID is valid and that specified type (cell/ic) matches the edge's type. If entering a source/destination pair, check that an arc of the specified type actually exists.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.