List of Messages
Parent topic: List of Messages

ID:328016 Wrong node type and/or width for node "<name>" in vector source file. Node in design is of type <type> and of width <number>, but node in vector source file is of type <type> and of width <number>.

CAUSE: You attempted to simulate a design using the vector source file you specified. However, the vector source file contains the specified node of the specified width, which does not match the node type and/or width of the same node in the design. This condition may produce an inaccurate simulation.

ACTION: To produce an accurate simulation, enter the correct signal type and/or width for the specified node in the vector source file.

Parent topic: List of Messages

Contact Altera | Legal Notice

Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.