List of Messages
Parent topic: List of Messages

ID:16561 The SignalTap II Logic Analyzer can't tap node "<bus_name>" because it is a bus. The SignalTap II Logic Analyzer only taps individual nodes. Remove the bus node and add each bit of the bus separately and then try to tap the node again.

CAUSE: You attempted to tap a bus node as a single wire.

ACTION: In the SignalTap II Logic Analyzer, on the Setup Tab, remove the bus node and add each bit of the bus separately and then try to tap the node again.

Parent topic: List of Messages

Contact Altera | Legal Notice

Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.