List of Messages |
CAUSE: You turned on the Manual Logic Duplication option for the specified source node. The source node already exists so the Fitter created a path between the source node and the destination node. However, the path between the new source node and the destination node might cause the design to not work as intended.
ACTION: No action is required. To avoid receiving this message in the future or if the design does not function correctly, turn off the Manual Logic Duplication option for the specified source node.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.