| List of Messages | |
CAUSE: The pins listed in the message have no output enables or have their output enables set to GND or VCC. If this is modified later, additional pin placement restriction may be necessary and may lead to a change in the fitting results.
ACTION: Refer to the submessage(s) in the Messages window to determine which pins have no output enable or a GND or VCC output enable. Add an output enable that is not GND/VCC to the pins.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.