List of Messages |
CAUSE: In the current design, the Design Assistant found the specified number of nodes where you connected a reset signal source (for example, an input reset pin) so it drives both input reset ports and ports that are not input reset ports. However, you should connect a reset signal source so it drives only input reset ports. The submessage(s) of this message list the node(s) that the Design Assistant found.
ACTION: Remove the connections between the reset signal sources and any ports they drive that are not input reset ports.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.