| List of Messages | |
CAUSE: The maximum DQS Frequency at the pin location is shown because the DQS frequency of the pin does not meet the design requirement.
ACTION: If possible, move the DQS pin to a supported location. If automatic placement is used, it is possible that there are not enough DQS pins with the frequency requirements required by the design.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.