List of Messages |
CAUSE: The specified I/O is with POD IO standard is connected to a termination control block that is not used in POD calibration mode. The termination atom in the OCT block should have the POD parameter set.
ACTION: Set a_oct_cal_mode in the termination atom that connects to the pin to A_OCT_CAL_MODE_POD.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.