List of Messages |
CAUSE: The Fitter could not place the specified blocks in such a way that the control-plane bonding signals could be routed. This message may appear because one or more of the specified blocks have location or region constraints that make it impossible to satisfy the control-plane bonding routing requirement.
ACTION: If you made a location assignment to the specified blocks, remove the assignment if possible. If this does not result in a successful fit, compile the design targeting a larger device.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.