List of Messages |
CAUSE: You manually edited a design file and specified a memory block size configuration for the byte enable port. However, the Fitter cannot support the port in the specified memory block size configuration.
ACTION: Change the memory block size configuration to support the port or disconnect the port. To avoid receiving this message in the future, Altera recommends using the MegaWizard Plug-In Manager to edit a RAM megafunction, rather than manually editing the design file for the megafunction. If you are using an EDA tool, contact the technical support for the EDA tool vendor. Otherwise, for further assistance contact Altera Technical Services at http://mysupport.altera.com.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.