List of Messages
Parent topic: List of Messages

ID:167033 HSSI input buffer <name> that is connected to CMU <name> with on-chip termination setting <name> requires a <name>, but there is none associated with the CMU

CAUSE: The Compiler cannot find a calibration block connected to the specified CMU of the specified HSSI input buffer that uses calibrated termination.

ACTION: Modify the design by either adding a gigabit transceiver block (GXB) calibration block associated with this CMU, or by making sure that the RX and TX pins are using external termination. To do this, open the altgx megawizard of the GXB block and make sure that the calibration block is being instantiated or that the external termination setting is used for the RX and TX OCT setting.

Parent topic: List of Messages

Contact Altera | Legal Notice

Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.