List of Messages |
CAUSE: Dynamic on-chip termination control is only supported for memory interface I/O configurations for Stratix V devices in the current release of the Quartus Prime software.
ACTION: Disconnect the dynamicterminationcontrol input for all output buffers in your design. Alternatively, you may be able to use DQ_GROUP QSF assignments to enable the dynamicterminationcontrol signal, which is physically routed through DQS logic block circuitry shared by a physical DQ group.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.