List of Messages |
CAUSE: The ASYNC_MODE parameter of the specified output phase alignment primitive is not set to NONE or CLEAR when the POWER_UP parameter is set to LOW.
ACTION: Check the design and make sure that the ASYNC_MODE parameter of the specified output phase alignment primitive is set to NONE or CLEAR. Alternatively, you can change the POWER_UP parameter to a value other than LOW.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.