List of Messages |
CAUSE: You specified values for port A and port B parameters; however, the total number of bits on side A and side B are not the same. When the OPERATION_MODE parameter is set to the specified value, the port A and port B parameters must be the same. This error usually occurs when you instantiate a megafunction directly in a text file rather than using the MegaWizard Plug-In Manager .
ACTION: Modify the design and change the port A and port B parameters so that the total number of bits on port A and port B are the same. To avoid receiving this message in the future, Altera recommends using the MegaWizard Plug-In Manager.
Copyright© 2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS, STRATIX, and all other brands, unless noted otherwise, and/or trademarks of Altera Corporation in the U.S. and other countries.