SRBR0

         Shadow Receive Buffer Register

Module Instance	Base Address	Register Address
`i_uart_uart_address_block`	`0xFF8D0000`	`0xFF8D0030`

Size: 32

Offset: 0x30

Access: RO

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`RSVD_SRBR0_31to8` `RO 0x0`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`RSVD_SRBR0_31to8` `RO 0x0`								`srbr0` `RO 0x0`

SRBR0 Fields

Bit	Name	Description	Access	Reset
31:8	`RSVD_SRBR0_31to8`	Reserved bits [31:8] - Read Only	`RO`	`0x0`
7:0	`srbr0`	Shadow Receive Buffer Register 0: This is a shadow register for the RBR and has been allocated sixteen 32-bit locations so as to accommodate burst accesses from the master. This register contains the data byte received on the serial input port (sin) in UART mode or the serial infrared input (sir_in) in infrared mode. The data in this register is valid only if the Data Ready (DR) bit in the Line status Register (LSR) is set. If in non-FIFO mode (FIFO_MODE == NONE) or FIFOs are disabled (FCR[0] set to zero), the data in the RBR must be read before the next data arrives, otherwise it will be overwritten, resulting in an overrun error. If in FIFO mode (FIFO_MODE != NONE) and FIFOs are enabled (FCR[0] set to one), this register accesses the head of the receive FIFO. If the receive FIFO is full and this register is not read before the next data character arrives, then the data already in the FIFO will be preserved but any incoming data will be lost. An overrun error will also occur.	`RO`	`0x0`

Bit

Name

Description

Access

Reset

31:8

RSVD_SRBR0_31to8

Reserved bits [31:8] - Read Only

RO

0x0

7:0

srbr0

Shadow Receive Buffer Register 0:
This is a shadow register for the RBR and has been allocated sixteen 32-bit locations
so as to accommodate burst accesses from the master.
This register contains the data byte received on the serial input port (sin) in UART
mode or the serial infrared input (sir_in) in infrared mode. The data in this register
is valid only if the Data Ready (DR) bit in the Line status Register (LSR) is set.
If in non-FIFO mode (FIFO_MODE == NONE) or FIFOs are disabled (FCR[0] set to zero), the
data in the RBR must be read before the next data arrives, otherwise it will be
overwritten, resulting in an overrun error.
If in FIFO mode (FIFO_MODE != NONE) and FIFOs are enabled (FCR[0] set to one), this
register accesses the head of the receive FIFO. If the receive FIFO is full and this
register is not read before the next data character arrives, then the data already
in the FIFO will be preserved but any incoming data will be lost. An overrun error
will also occur.

RO

0x0