ecc_enable

         Enable controller ECC check bit generation and correction 
      
Module Instance Base Address Register Address
i_nand_config 0xFFB80000 0xFFB800E0

Offset: 0xE0

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

flag

RW 0x1

ecc_enable Fields

Bit Name Description Access Reset
0 flag
Enables or disables controller ECC capabilities. When enabled, controller calculates
                            ECC check-bits and writes them onto device on program operation. On page reads,
                            check-bits are recomputed and errors reported, if any, after comparing with stored
                            check-bits. When disabled, controller does not compute check-bits.
                            [list][*]1 - ECC Enabled  [*]0 - ECC disabled[/list] 
RW 0x1