Thunderbolt™ 3 and 4 DCH Driver for Windows® 10 for Intel® NUC

19402

Introduction

Installs the DCH-compliant Thunderbolt™ bus driver for the Intel® NUC products using Windows® 10.

Available Downloads

  • Windows 10, 64-bit*
  • Size: 33.3 MB
  • SHA1: 4719F3BCFC393752A373B2802AEF8FCF49579FBA

Detailed Description

Purpose

Installs the DCH-compliant Thunderbolt™ bus driver for the Intel® NUC products with Thunderbolt using Windows® 10. This driver is required if you plan to connect Thunderbolt devices.

What are DCH drivers? Click here for more information.

How to install

Double-click Thunderbolt™ Software Installer.exe.

Note

If the driver won't install and you are using a supported operating system, try one or both of the following:

  • Plug a Thunderbolt device into the Intel NUC and run the installer again.
  • Uninstall the current driver, then run the installer again.

The Thunderbolt Control Center should load automatically after the driver is installed and if or when you're connected to the Internet. If it doesn't, you can download it from this link: Thunderbolt Control Center software (available on the Microsoft Store)

The Thunderbolt Control Center allows you to approve and manage Thunderbolt devices.

Some IT departments might have a group policy that prevents you from downloading apps from the Windows Store*. They can choose to set up a private store with approved apps. See the following for more information:

Supported Operating Systems

  • Microsoft Windows® 10-64 - October 2018 Update 1809 (RS5) or later

Not sure if this is the right driver for your Intel® NUC?

Run Intel® Driver & Support Assistant to automatically detect updates.

 

This download is valid for the product(s) listed below.

Automatic Driver and Software Updates

Identify your products and install Intel driver and software updates for your Windows* system.

Get started