Intel® FPGA Voltage Sensor IP Core User Guide

ID 683781
Date 2/09/2018
Public
Document Table of Contents

7. Document Revision History for Intel® FPGA Voltage Sensor IP Core User Guide

Date Version Changes
February 2018 2018.02.09
  • Rebranded as Intel® .
  • Beginning from the Intel® Quartus® Prime software version 17.1, the name of this IP core has been changed from Altera Voltage Sensor IP Core to Intel® FPGA Voltage Sensor IP Core.
  • Added Intel® Cyclone® 10 GX device information.
  • Added the Intel® FPGA Voltage Sensor IP Core Implementation Guide chapter.
  • Added the supported configuration variants in the Intel® FPGA Voltage Sensor Parameters table.
  • Added the Channel Selection table.
  • Added a note to indicate only unipolar mode is supported in the unipolar selection bits of the Controller Core Registers table.
  • Updated the signal names in the CSR Interface table.
  • Updated the signal names in the Response Interface table.
  • Updated the signal name in the Interrupt Interface table.
  • Updated the Bit Name header column in the Controller Core Registers table.
  • Updated the voltage sample register in the Sample Store Core Registers table.
  • Updated the Sample Storage Core Block Diagram.
  • Updated the Voltage Sensor Controller with Avalon-MM Sample Storage figure.
  • Updated the Voltage Sensor Controller with External Sample Storage figure.
  • Minor text edits to the One Round Conversion and Continuous Conversion sections.
  • Minor text edits to the Configuring the Voltage Sensor Controller section.
September 2016 2016.09.01
  • Changed instances of Quartus II to Quartus Prime.
  • Updated the data width in the Response Interface table.
  • Updated the Voltage Sample bits in the Sample Store Core Registers table.
  • Removed the bipolar mode support.
May 2015 2015.05.04 Initial release.

Did you find the information on this page useful?

Characters remaining:

Feedback Message