4.5.6. PIPE Lane Reset Staggering
This section focuses on the staggering for PHY lane resets driven by a soft IP controller. The IP controller executes a part of the reset procedure for the PHY. It only performs the lane reset procedure when the IP itself is out of reset. Each lane has its own lnX_pipe_direct_pld_pcs_rst_n_i driven by the IP controller. Each IP can reset its respective lane independent of the other IPs.
Reset staggering is optional. The staggering is to reduce the power distribution network (PDN) noise during power-up. If implemented, the reset staggering should start after lnX_pipe_direct_tx_transfer_en is asserted.
The staggering interval must be set to more than 100ns. The lane resets are staggered in such a way that they start from lane 0 to lane 15 for the PIPE Direct x16 mode and lane0 to lane 7 for any PIPE Direct bundle mode. Both reset assertion and deassertion must be staggered.
The lnX_pipe_direct_powerdown_i and lnX_pipe_direct_rxstandby_i PIPE signals also require lane staggering per bundle. The staggering must be greater or equal to a x4 bundle. For example, in the PIPE Direct 8x2 bundle mode, the lane staggering for the mentioned PIPE signals must be grouped in x4 or greater.
Did you find the information on this page useful?