DSP Builder for Intel® FPGAs (Advanced Blockset): Handbook

ID 683337
Date 10/02/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

12.1.2.1. FIR Filter Avalon-MM Interfaces

All DSP Builder FIR blocks can provide Avalon memory-mapped interfaces to coefficients, allowing you to change the coefficient values at run time.
  • To allow read, write, or readwrite access to coefficients from system bus interfaces, select Read, Write, or Readwrite for the FIR block Bus mode. Select Constant to disable this interface.
  • Specify the bus address width and data type on the FIR block and on the Avalon memory-mapped Settings block. FIR blocks automatically generate the appropriate bus logic and interface for your design.
  • To place the bus logic on a separate clock domain specify Separate bus clock in the Avalon memory-mapped Settings block.
  • DSP Builder hides the agent interface ports by default in the simulation model. Use the BusStimulus block to access this interface during simulation (similar to Interface blocks). Use the base address specified on the FIR block for accessing the coefficients.
  • In generated RTL, DSP Builder adds these ports to FIR blocks and routes them to the Avalon memory-mapped agent interface. Set the width of data and address ports (Avalon Data and Address Width) in the Avalon memory-mapped Settings block.
Note: If the FIR coefficient is wider than Avalon memory-mapped data width, the design requires several accesses to write or read a single coefficient.

In your higher level system, access FIR coefficients through the agent interface at the base address you specified on the FIR block.

Note: The FIR base address is now an offset from the base address assigned to the agent interface in your Platform Designer system.

When you expose bus interface ports in the Simulink design (turn on Expose Bus Interface), a valid sub-set of Avalon memory-mapped agent interface ports appears on the block based on the selected bus mode. You can now make direct connections to these ports in the Simulink model for accessing the coefficients. The FIR coefficient width sets the data ports (write and read). DSP Builder places bus agent logic on the system clock domain.

Table 35.  FIR Filter Avalon-MM PortsYour design contains address when Read/Write Mode is not Constant, write when Read/Write Mode is Write or ReadWrite, read and valid when Read/Write Mode is Read or ReadWrite
Name Direction Description
address Input

Address of the request. DSP Builder adds address to your design when Bus Mode is not set to Constant.

The port width depends on the Bus Address Width in the Avalon Memory-Mapped Settings block.

For the first coefficient use the Base Address you specify for the block and for the last one use: Base Address + Number Of Coefficients -1

data Input

Write data.

The port width depends on the coefficient width of the FIR block.

Set data and address and assert write port simultaneously to initiate a write request.

read Input

Read enable.

Set the address to a valid address and assert this single-bit input simultaneously every time you want to initiate a read request.

After sending a read request, wait for valid to be asserted indicating that read data is available on readdata.

You don’t need to wait for the completion of the first read request to initiate a second read request. The agent supports pipelined reads. DSP Builder provides the responses in the exact same order you send the read requests.

write Input

Write enable.

Assert this single-bit input every time you need to initiate a write request.

Do not assert read and write ports at the same time, otherwise, you see undefined behavior.

readdata Output

Read data.

DSP Builder sets the port width the same as the FIR coefficient width. This output provides data for read responses.

Only capture this output if you assert valid output.

valid Output

Read data valid.

This single-bit output indicates that valid data is available on readdata.