• 2021.4
  • 09/27/2021
  • Public Content
Contents

Using input_node

By default, an
input_node
is constructed in the inactive state:
template< typename Body > input_node( graph &g, Body body, bool is_active=true )
To activate an inactive
input_node
, you call the node’s function activate:
input_node< int > src( g, src_body(10), false ); // use it in calls to make_edge… src.activate();
All
input_node
objects are constructed in the inactive state and usually activated after the entire flow graph is constructed.
For example, you can use the code in Data Flow Graph. In that implementation, the
input_node
is constructed in the inactive state and activated after all other edges are made:
make_edge( squarer, summer ); make_edge( cuber, summer ); input_node< int > src( g, src_body(10), false ); make_edge( src, squarer ); make_edge( src, cuber ); src.activate(); g.wait_for_all();
In this example, if the
input_node
was toggled to the active state at the beginning, it might send a message to squarer immediately after the edge to squarer is connected. Later, when the edge to cuber is connected, cuber will receive all future messages, but may have already missed some.
In general it is safest to create your
input_node
objects in the inactive state and then activate them after the whole graph is constructed. However, this approach serializes graph construction and graph execution.
Some graphs can be constructed safely with
input_node``s active, allowing the overlap of construction and execution. If your graph is a directed acyclic graph (DAG), and each ``input_node
has only one successor, you can activate your
input_node``s just after their construction if you construct the edges in reverse topological order; that is, make the edges at the largest depth in the tree first, and work back to the shallowest edges. For example, if src is an ``input_node
and
func1
and
func2
are both function nodes, the following graph would not drop messages, even though src is activated just after its construction:
const int limit = 10; int count = 0; graph g; oneapi::tbb::flow::graph g; oneapi::tbb::flow::input_node<int> src( g, [&]( oneapi::tbb::flow_control &fc ) -> int { if ( count < limit ) { return ++count; } fc.stop(); return {}; }); src.activate(); oneapi::tbb::flow::function_node<int,int> func1( g, 1, []( int i ) -> int { std::cout << i << "\n"; return i; } ); oneapi::tbb::flow::function_node<int,int> func2( g, 1, []( int i ) -> int { std::cout << i << "\n"; return i; } ); make_edge( func1, func2 ); make_edge( src, func1 ); g.wait_for_all();
The above code is safe because the edge from
func1
to
func2
is made before the edge from src to
func1
. If the edge from src to func1 were made first,
func1
might generate a message before
func2
is attached to it; that message would be dropped. Also, src has only a single successor. If src had more than one successor, the successor that is attached first might receive messages that do not reach the successors that are attached after it.

Product and Performance Information

1

Performance varies by use, configuration and other factors. Learn more at www.Intel.com/PerformanceIndex.