MAX 10 - I2C Remote System Update Example

714747
5/17/2016

Introduction

This example demonstrates a remote system upgrade using the I2C protocol. It requires two kits- a Max 10M50 Development Kit to be used as the I2C master, and a Max 10M08 Evaluation Kit to be used as the I2C slave. The Max 10M50 controls the remote upgrading of the Max 10M08 device.
IP Cores (20)
IP Core IP Core Category
PIO (Parallel I/O) Other
Nios II Gen2 Processor NiosII
IRQ Mapper QsysInterconnect
JTAG UART ConfigurationProgramming
MM Interconnect QsysInterconnect
Avalon-ST Adapter QsysInterconnect
Avalon-ST Error Adapter QsysInterconnect
Avalon-MM Slave Agent QsysInterconnect
Avalon-ST Single Clock FIFO QsysInterconnect
Avalon-MM Slave Translator QsysInterconnect
Memory-Mapped Demultiplexer QsysInterconnect
Memory-Mapped Multiplexer QsysInterconnect
Avalon-MM Master Agent QsysInterconnect
Memory-Mapped Traffic Limiter QsysInterconnect
Avalon-MM Master Translator QsysInterconnect
Memory-Mapped Router QsysInterconnect
Altera On-Chip Flash Flash
On-Chip Memory (RAM or ROM) OnChipMemory
Avalon ALTPLL ClocksPLLsResets
Reset Controller QsysInterconnect

Detailed Description

Prepare the design template in the Quartus Prime software GUI (version 14.1 and later)


Note: After downloading the design example, you must prepare the design template. The file you downloaded is of the form of a <project>.par file which contains a compressed version of your design files (similar to a .qar file) and metadata describing the project. The combination of this information is what constitutes a <project>.par file. In releases 16.0 or newer, you can simply double click on the <project>.par file and Quartus will launch that project.


The second means to bring up the project template is through the New Project Wizard (File -> New Project Wizard). After entering the project name and folder on the first panel, the second panel will ask you to specify an empty project or project template. Select project template. You will see a list of Design Templates projects that you have loaded prior as well as various "Baseline Pinout Designs" that contain the pinout and settings for a variety of development kits. If you don't see your design template in the list, click on the link that states install the Design Templates circled below:



Browse to the <project>.par file you downloaded, click next, followed by Finish, and your design template will be installed and displayed in the Project Navigator pane in Quartus.


Note: When a design is stored in the Design Store as a design template, it has been previously regression tested against the stated version of Quartus software. The regression ensures the design template passes analysis/synthesis/fitting/assembly steps in the Quartus design flow.



Prepare the design template in the Quartus Prime software command-line


At the command-line, type the following command:

quartus_sh --platform_install -package <project directory>/<project>.par


Once the process completes, then type:

quartus_sh --platform -name <project>



Note:

* ACDS Version: 16.0.0 Standard


Tags Details

Family

Intel® MAX® 10 FPGAs

Quartus Edition

Intel® Quartus® Prime Standard Edition

Quartus Version

16.0

Other Tags

Intel® FPGAs

FPGA Design Store