ALTERA DOES NOT WARRANT THAT THE FUNCTIONS CONTAINED IN THIS PATCH 
WILL MEET YOUR REQUIREMENTS, OR THAT THE OPERATION OF THIS PATCH 
WILL BE UNINTERRUPTED OR ERROR-FREE. 

//**************************************************************** 
quartus-10.0-1.150-readme.txt 
Readme file for Quartus II 10.0 SP1 Patch 1.150
Copyright (C) Altera Corporation 2010 All right reserved. 
Patch created on October 13 2010
Patch SPR#: 356399 
SPRs fixed: 355076
//**************************************************************** 

Problem:  The UniPHY QDRII IP core operating in full-rate mode can 
          exhibit intermittent failure during calibration. The 
          failure is caused by an unreliable asynchronous transfer 
          going from the AFI clock domain to the read-capture clock 
          domain.


Solution:  The patch fixes the issue by ensuring that the 
           asynchronous signal can reliably be captured by the 
           read-capture clock domain. This is done by ensuring that 
           the asynchronous signal lasts for two read-capture clock 
           cycles, and that there is no combinational logic in the 
           cross-clock-domain path.


Caution - You must either have previously installed the 
          Quartus II 10.0 SP1 software or must 
          install the Quartus II 10.0 SP1 software 
          before installing this patch. Otherwise, the patch will 
          not be installed correctly and the Quartus II 
          software will not run properly.