Before attempting to install a processor, carefully review the documentation that came with your system and make sure that you will not be voiding your warranty by opening the computer or replacing your processor.
Intel recommends the processor should be installed by a computer professional since this electronic device may cause serious damage to the installer, system and processor if installed improperly.
- Make sure that your laptop can accommodate the processor that you want to install. Check for motherboard, BIOS, and thermal compatibility by using the laptop manufacturer's documentation, or by contacting the vendor.
- Obtain access to your processor socket as described in the documentation for your system.
- If the cooling solution prevents you from accessing the processor socket, you may need to remove it. Instructions on how to remove your cooling solution should be provided in the documentation that came with the system.
- To uninstall the current processor, use a screwdriver to disengage (open) the socket actuator, as shown in Figure 1 below. The socket actuator should open after only a half turn or so, and you should then be able to remove the processor with your fingers.
Figure 1: Disengaging the Socket Actuator
It is important to keep in mind
- Using the method shown in Figure 2, place the new processor into the socket. Align the processor's pin A1 with the arrow on the micro-FCPGA socket. The pin A1 of the processor is identified with an embroidered corner and the pin A1 of the socket is identified with a small arrow. If the processor does not drop completely into the socket, turn the actuator until the processor drops completely in.
Figure 2: Aligning the Processor in the Socket
||You should not have to press down on the processor. If the processor does not drop completely into the socket, turn the actuator until the processor drops completely in.|
- While gently holding the processor down with your finger, secure the processor in the socket by closing the socket actuator with a screwdriver (See Figure 1).
- Reattach the cooling system, and reassemble the system per documentation that came with the system.
- Your system may require special voltage and speed settings for the new processor to function correctly. Some systems are auto-configuring, while others are set with jumpers, dip-switches, or within the CMOS setup program. Consult your system manufacturer's documentation to determine the correct settings.
- It is important that you install the cooling system properly per the installation manual. If the laptop or laptop OEM documentation specifies to use a piece of thermal interface material, a new piece must be applied. Since the thermal interface material varies from computer to computer, you must get the material from the laptop or laptop vendor.
This applies to: