After the initial installation of a Xircom® PortStation kit and set of Xircom® PortStation Modules, you can obtain additional PortStation Modules and add them with no further installation of software.

Note: You must be using the latest driver for your module.

1. Disconnect the PortStation USB cable from the computer or USB hub.
2. Disconnect the AC power module and remove the PortStation Output Termination End Cap from the PortStation assembly.
3. Plug the new module into the last PortStation Module, then reconnect the PortStation Output End Cap and AC power module.
4. Plug the PortStation USB cable back into the computer or USB hub. Boot the machine. The correct drivers will automatically start.

1. Run the Launcher.exe program on the Xircom Driver CD.
2. Click Online Documentation.
3. Click Getting Started: Hardware and Driver Installation.
4. Click Installing PortStation Drivers.
5. Click Windows NT. Follow the instructions for installing your module.

This applies to:

Xircom® PortStation 4 Port USB Hub Module (STUH4) Xircom® PortStation 56K GlobalACCESS Modem Adapter Module (STM56G) Xircom® PortStation 56K Modem Adapter Module (STM56V) Xircom® PortStation 7 Port USB Hub Module (STUH7) Xircom® PortStation Dual 9-pin Serial Module (STDB9) Xircom® PortStation Dual PS2 Module (STPS22) Xircom® PortStation End Cap Module (STTERM) Xircom® PortStation Ethernet 10 Module (STE10) Xircom® PortStation Parallel Module (STDB25)