When using the CE adapter with a Novell server, it is recommended that you run CECFG.EXE DRIVER=ODI with the valid parameters such as INT and MEM values in the NET.CFG. CECFG.EXE is executed prior to executing SERVER and loading the .LAN drivers.

When using SLIST, the computer will not attach to the server, nor will it show up on the network. Check the frames loaded and make sure that they are binding to the CE LAN adapter. Use MONITOR and use LAN INFORMATION or type CONFIG at the SERVER CONSOLE to see if the frames MATCH the workstations NET.CFG.

Also, since INT=10 it not a valid interrupt when loading the .LAN driver, DataBook machines will not work.

Note: There is an error on Page 55 of the manual. The MEM=D000 SHOULD BE MEM=D0000

This applies to: