|
The following is a sample configuration for NetManage by Chameleon. This configuration is based on test results of using the CreditCard Ethernet (CE) with the NetManage software.
CONFIG.SYS
DEVICE=C:\WINDOWS\HIMEM.SYS
DEVICE=C:\WINDOWS\EMM386.EXE NOEMS X=D000-D1FF
DEVICE=C:\NETMANAG\PROTMAN.DOS /I:C:NETMANAG
DEVICE=C:\NETMANAG\CECFG.EXE DRIVER=NDIS
DEVICE=C:\NETMANAG\CENDIS.EXE
DEVICE=C:\NETMANAG\NETMANG.DOS
Note: For the PE3 adapter, do not load the resource manager line (CECFG.EXE), and load PE3NDIS.EXE rather than CENDIS.EXE.
PROTOCOL.INI
[protman]
drivername=protman$
[xircomnet]
drivername=xircom$
ioaddress=0x300
int=5
mem=0xd000
iowordsize=16
[netmanag]
drivername=netmng$
bindings=xircomnet
Note: For the PE3 adapter, the [xircomnet] section should contain only the drivername parameter.
This applies to:
| 
