|
The Elite Gateway* telephony commands are used for setting or displaying telephony related options.
For information on how to connect and use the CLI, see the Using the Command Line Interface document.
Telephony Commands
tel show pcm_gain_level
The tel show pcm_gain_level command displays the gain level setting of the PCM codec's receive channel.
Syntax Description
This command has no arguments or keywords.
tel show port [port#]
The tel show port command displays the hook state of a telephony port.
Syntax Description
| Port# |
Number of the port. |
Default
If the port number is not specified, the CLI displays the hook state of all telephony ports.
tel show ring_freq
The tel show ring_freq command displays the frequency of the ring signal that the Elite Gateway sends to FXS ports.
Syntax Description
This command has no arguments or keywords.
tel set pcm_gain_level {1|2|3|4|5}
The FXO ports might be connected to a central office switch or PBX via local loop which may be several miles away. To compensate for signal distortion in the local loop, the Elite Gateway's PCM codec is designed in such a way that users can adjust its gain level before transmitting an analog signal to the local loop. The tel set pcm_gain_level command is used to set the gain level for the PCM codec for compensating signal loss in the local loop.
Syntax Description
| 1 |
Set gain level to -1 dB |
| 2 |
Set gain level to 0 dB |
| 3 |
Set gain level to +1 dB |
| 4 |
Set gain level to +2 dB |
| 5 |
Set gain level to +3 dB |
Default
The default setting is -1 dB.
Note: The PCM gain level setting is only meaningful to FXO ports. It is not applicable to FXS ports.
tel set ring_freq {1|2|3|4}
Use the tel set ring_freq command to set the frequency of the ringer that the Elite Gateway uses to ring a FXS port.
Syntax Description
| 1 |
Set ring freq to 17 Hz |
| 2 |
Set ring freq to 20 Hz |
| 3 |
Set ring freq to 25 Hz |
| 4 |
Set ring freq to 50 Hz |
set call_wait
This command enables or disables the H.450 call waiting:
set call_wait {on | off}
Syntax Description
| on |
Enable H.450 call wait |
| off |
Disable H.450 call wait |
Factory Default
off
show call_wait
This command displays the setting of H.450 call wait option.
show call_wait
Syntax Description
This command has no arguments or keywords.
This applies to:
| 
