Elite Gateway* Technical Specifications

Telephony Interface 4 ports loop start FXO 4 ports loop start FXS Network Interface Ports 1 10/100Base-T, auto sensing, RJ45 Voice codec support G.711 PCM 64kbps (A-law and µ-law) G.723.1A ACELP/M-MLQ (5.3, 6.3kbps) G.729AB CS-ACELP (8kbps) Fax ITU-T V.21, V.27ter, V.29, V.33 and V.17 Fax over IP protocol T.38 Echo cancellation G.168 compliant, 16 ms tail length Simultaneous connection 8 channels voice/fax Voice processing Voice activity detection DTMF detection/generation Echo cancellation Comfort noise generation Call progress detection Gain control Call control H.323 Management Built HTTP server allowing management from Web browser Command line interface allowing management from VT-100 terminal or Telnet client Software upgrade Flash memory and built-in TFTP allowing software upgrade via network Power 90-240 VAC, 20 Watts, 50-60 Hz Environmental Operating temperature: 0° to 45° C (32° to 113° F) Storage temperature: -10° to 65° C (-4° to 149° F) Humidity: 10% to 85% (non-condensing) Operating altitude: Up to 3,000m (10,000 ft) Storage altitude: Up to 4,570 m (15,000 ft) Dimension (H x W x D 2.6 x 17.5 x 10.8 in (44 x 445 x 275 mm) Weight 4.2 kg (9.3 lb) 5.1 kg (11.2 lb) with two modules installed Compliances EMI FCC Part 15 Class A EN55022 Class A (CISPR-22 Class A) VCCI Class A CE Safety UL 1950 CE Mounting Desktop or 19" mounting

FXO Card Technical Specifications

FXS Card Technical Specifications

E&M Card Technical Specifications
Type V, four wires

Console Port
The console port uses a DB-9 RS-232 connector. The supplied straight-through RS-232 cable connects the console port of the Elite Gateway to a PC or terminal. Pinout for the port is described in the following table.

LAN Port
The 10/100 LAN port uses standard RJ-45 connector and Ethernet pinouts. The following diagram and table show the pinout on the port connector. When connecting the LAN port to switches or repeaters, you must use a straight-through cable.

RJ45 pin Signal 1 RxD+ 2 RxD- 3 TxD+ 4 Not connected 5 Not connected 6 TxD- 7 Not connected 8 Not connected

FXO Port Pin Assignments
The FXO Telephony Interface Module has 4 RJ11C/W modular jacks. The following diagram and table show the assignments of the pin for the RJ11 port.

RJ-11 pin Signal 1 Not connected 2 Tip 3 Ring 4 Not connected

FXS Port Pin Assignments
The FXS Telephony Interface Module has 4 RJ11C/W modular jacks. The following diagram and table show the assignments of the pin for the RJ11 port.

RJ-11 pin Signal 1 Not connected 2 Tip 3 Ring 4 Not connected

E&M Pin Assignment
The pin assignment for the current E&M (V2.0 and below) supports type V 4W only. Later releases will support all other types. The description below only applies to V2.0 and below E&M line module.

The pin assignment for each port starts from the left to the right. The color coding scheme is just a reference, it depends upon the cable used and the I/P and O/P sense configuration from the line module side.

This applies to:

Elite Gateway*