|
The command line interface (CLI) network commands allow the user to set values for network parameters on the Elite Gateway*.
For information on how to connect and use the CLI, see Using the Command Line Interface.
net reset
Use the net reset command to reset the Elite Gateway. The CLI will prompt you to confirm the command before resetting the Elite Gateway.
Syntax Description
This command has no arguments or keywords net set gateway ip_addr
Use the net set gateway command to assign a default gateway (router) for the Elite Gateway. The default gateway routes packet data outside or your IP subnet.
Syntax description
| ip_addr |
The IP address of the default gateway. IP address of 0.0.0.0 stands for no default gateway. |
Note: The new setting will not take effect until the Elite Gateway is reset. net set http {on|off}
The Elite Gateway allows you enable of disable its built-in HTTP server. Use the net set http command to enable or disable the HTTP server.
Syntax description
| On |
Enable HTTP server. This allows users to access the Elite Gateway from Web browser. |
| Off |
Disable HTTP server. | net set ip ip_addr
Use the net set ip command to assign an static IP address to the Elite Gateway.
Syntax description
| ip_addr |
The IP address of the Elite Gateway. |
Note: The new IP address will not take effect until the Elite Gateway is reset. net set ip_preced ip_preced
The Elite Gateway allows you to set the 3-bit IP precedence field in the IP header for all the voice packets it sends out. Use the net set ip_preced to set the IP precedence field.
Syntax description
| ip_preced |
The IP precedence to be assigned to all the voice packets sent by the Elite Gateway. The IP precedence must be in the range of 0 through 7 (7 is the highest priority). |
Note: The new setting will not take effect until the Elite Gateway is reset. net set mask ip_mask
Use the net set mask command to set the IP subnet mask for the Elite Gateway.
Syntax description
| ip_mask |
The subnet mask of your network. | Note: The new setting will not take effect until the Elite Gateway is reset. net set speed {10|100|auto}
The Elite Gateway allows you set the link speed for its Ethernet interface. Use the net set speed command to set the Ethernet link speed.
Syntax description
| 10 |
Fixed the Ethernet speed at 10 Mbps. |
| 100 |
Fixed the Ethernet speed at 100 Mbps. |
| Auto |
Enable the 10/100 Mbps auto-negotiation capability. | net set user_pw password password
Use the net set user_pw command to change the password for Telnet user.
Syntax description
| password |
The new password. The password must be equal to or less than 7 alphanumeric characters. It must be identically typed twice for the Elite Gateway to be certain about the new password. | net show
The net show command displays all the network settings.
Syntax description
This command has no arguments or keywords
Example
The following example shows how to display network settings:
Console> net show ******************* Net Parameters *******************IP address = 210.243.230.173.IP sub net mask = 255.255.255.192.Default gateway IP address = 210.243.230.129.IP precedence = 1Ethernet MAC address = 00-50-2d-00-08-9dEthernet speed setting = 10/100 Mbps auto-negotiationUSER password = 123HTTP server state = on****************************************************Console> | | net show hwstat
The net show hwstat command displays the hardware configuration of the Elite Gateway.
Syntax Description
This command has no arguments or keywords
Example
The following example shows how to display hardware configuration:
Console>net show hwstat ****************** Hardware Configuration ****************** Flash EEPROM type: MX29L1611 Flash EEPROM size: 64 sectors, 64 KB/sector DRAM size: 8 MB LAN interface: 100 Mbps half duplex. Link UP Line card 1 type: FXS Line card 2 type: FXS************************************************************Console> | |
This applies to:
| 
