|
System compatibility
PCI systems - PCI specification 2.2
Media (Cable) connectors
------------------------
RJ45
Data Rate mode
--------------
10 or 100 Mbps
Interrupt levels
----------------
PCI: INTA (Interrupt pin 1)
On board cache
---------------
6K
Power requirements
------------------
1.06 Watts (212 mA) @ +5 VDC Maximum (100Mbps Full duplex maximum network load)
Isolation voltage
-----------------
1750V
Operating temperature
---------------------
| Operating |
0 to +55 °C @ < 2 °C/min |
| Non-operating |
-40 to +70 °C @ < 4 °C/min | |
Humidity
--------
| Non-operating |
RH of 92% at +55 C @ < 25% RH/hr |
| Operating |
RH of 85% at +55 C @ < 25% RH/hr |
| Packaged Product |
RH of 92% at +55 C @ < 40% RH/hr | |
Dimensions
----------
2.0 inches x 4.7 inches (measured without the bracket)
Diagnostic LED
---------------
2 LED's - Activity/Link and 100 Mbps
Diagnostic software
-------------------
On-board On-network Responder
Estimated Mean Time Between Failures (MTBF)
--------------------------------------
2,322,070 hours ( ~265 years)
(The FIT numbers used for this calculation were taken from the MTBF Prediction - Component Default Table of the "Environmental & Reliability Board & System Validation Test Handbook", Intel Document #662394-02).
Certifications
----------------
This product has been or will be tested, approved, and certified as measured by the following:
- FCC Part 15, Subpart J, Class B
- UL Listed
- CE DECLARED COMPLIANCE: Council Directive 89/336/EEC when tested in a representative chassis via standards EN55022 and EN50082-1. Council Directive 72/23/EEC via standard EN60950
This applies to:
| 
