|
System compatibility
PCI systems - PCI specification 2.1
Media (Cable) connectors
------------------------
RJ45
Data Rate mode
--------------
10 or 100 Mbps
Interrupt levels
----------------
PCI: INTA (Interrupt pin 1) and INTB (Interrupt pin 2)
On board cache
--------------
12K - (6K per each 82558 LAN controller)
Power requirements
-----------------
5.25 Watts (1050 mA) @ +5 VDC Maximum (100Mbps Full duplex maximum network load on both ports)
Isolation voltage
-----------------
1900V
Operating temperature
---------------------
0 - 55 degrees C (operating)
-40 - +70 degrees C (non-operating)
Humidity
--------
| Non-operating |
RH of 92% at +55 C @ < 25% RH/hr |
| Operating |
RH of 85% at +55 C @ < 25% RH/hr |
| Packaged Product |
RH of 92% at +55 C @ < 40% RH/hr |
|
Dimensions
----------
4.2 inches x 5.9 inches (measured without the bracket)
Diagnostic LED
---------------
6 LED's - Activity, Link and 100 Mbps for each port
Diagnostic software
-------------------
On-board On-network Responder
Estimated Mean Time Between Failures (MTBF)
--------------------------------------
1,430,226 hours (~163 years)
(The FIT numbers used for this calculation were taken from the MTBF Prediction - Component Default Table of the "Environmental & Reliability Board & System Validation Test Handbook", Intel Document #662394-02).
Certifications
----------------
This product has been tested, approved, and certified as measured by the following:
- FCC Part 15, Subpart J, Class B
- UL Listed
- CE DECLARED COMPLIANCE: Council Directive 89/336/EEC when tested in a representative chassis via standards EN55022 and EN50082-1. Council Directive 72/23/EEC via standard EN60950
This applies to:
| 
