|
The Intel® Server Board SE7501BR2 has 4 DIMM sockets supporting up to 8 GB of Registered ECC DDR266 memory using four 72-bit DIMM modules. These four DIMM sockets constitute two memory banks; Bank1 with contiguous sockets labeled DIMM1A & DIMM1B, and Bank2 with contiguous sockets labeled DIMM2A & DIMM2B. Memory must be installed in pairs; DIMM Bank1 must be populated before DIMM Bank2. Memory within a DIMM bank must be identical; between banks only the DIMM size may be different. DIMM and memory configurations must adhere to the following:
- DDR266 registered ECC 2.5V modules (in compliance with the DDR JEDEC DIMM Specification)
- DIMM organization: x72 ECC
- Pin Count: 184
- Memory capacity: 128MB, 256MB, 512MB, 1G and 2G
- Serial PD: JEDEC Rev 2.0
- Interface: SSTL2
- CAS Latency: 2 & 2.5
- Minimum configuration: 256MB using two 128MB DIMMs in Bank1
- One or two memory banks may be populated
Note: This content is updated frequently, so please refresh your browser to ensure that you are downloading the most current version.
Note: Memory qualification is done by testing identical memory modules in all DIMM sockets. Memory qualification does not include testing of mixed DIMM type and/or vendors; mixing of DIMM type and/or vendors is not recommended.
Note: PDF Files require Adobe Acrobat* Reader†
† This link will take you off of the Intel Web site. Intel does not control the content of the destination Web Site.
This applies to:
| 
