|
Intel® Entry Server Board SE7210TP1-E has 4 DIMM sockets, which can hold up to 4 GB of Unbuffered ECC and non-ECC DDR266, DDR333 or DDR400 memory using four 72-bit DIMM modules. The following memory features are supported:
- DDR266, DDR333 and DDR400 Unbuffered ECC and non-ECC compatible 2.5V modules (in compliance with the DDR JEDEC DIMM Specification).
- DIMMs with capacity of 128MB, 256 MB, 512 MB, 1G. Other DRAM sizes may function correctly but will not be validated.
- Minimum configuration is 128MB using one 128MB DIMM.
Caution: Third party memory vendors may use the same module part number with different DRAM vendors and die revisions. To insure proper system operation, verify that each DRAM vendor and die revision has been separately tested and qualified. Please notify CMTL if there is a discrepancy.
Note: This list is not intended be all-inclusive. It is provided as a convenience to Intel's general customer base, but Intel does not make any representations or warranties whatsoever regarding the quality, reliability, functionality, or compatibility of these memory modules.
Note: PDF Files require Adobe Acrobat* Reader†
† This link will take you off of the Intel Web site. Intel does not control the content of the destination Web Site.
This applies to:
| 
