Server Products
Intel® RAID Controllers
RAID Volume Recovery Procedures

Use the following recovery procedures in order to attempt to recover failed RAID volumes that have been marked "failed" by the RAID firmware. RAID volumes enter the "failed" status due to the firmware detecting multiple failed hard disk drives that are members of the failed RAID volume. The failure detected by the firmware can be due to, but not limited to, SCSI bus error conditions, system power spikes, SCSI cabling or SCSI termination. The RAID firmware will allow the user to recover from a very high percentage of these false failures if you follow the procedure enclosed in the pdf below.

PDF RAID Recovery Procedures [PDF]
Size: 40476 bytes
Date: 12/20/01 3:25:08 PM

Note: PDF Files require Adobe Acrobat Reader

This applies to:

Intel® Server RAID Controller SRCU31L

Solution ID: CS-010767
Last Modified: 03-Oct-2014
Date Created: 03-May-2004
Back to Top