|
Symptom(s):
Serial ATA mode switching utility for enable RAID or Base mode on Intel® Entry Server Board SE7210TP1-E.
Solution:
Serial ATA mode switching utility for this Intel® Entry Server Board SE7210TP1-E is no longer required. Features have been added to the BIOS Setup Utility to easily and conveniently change the Serial ATA controller's mode.
To configure Serial ATA RAID Mode:
- Power-on or reset system
- Press F2 during POST to enter BIOS Setup Utility
- Select the "Advance" menu and "IDE Configuration" sub-menu
- Highlight "ATA Configuration"
- Choose "ENABLE SATA RAID" and press Enter
- Press F10 to save and exit
- During POST when "Adaptec* Host RAID Configuration Utility appears press Ctrl+A to enter and configure the Serial ATA RAID array
To configure Serial ATA Base Mode: (This is non-RAID mode)
- Power-on or reset system
- Press F2 during POST to enter BIOS Setup Utility
- Select the "Advance" menu and "IDE Configuration" sub-menu
- Highlight "ATA Configuration"
- Choose "CONFIG SATA ATA" and press Enter
- Press F10 to save and exit
WARNING: Do not make changes to the ATA configuration if the hard drives already contain an operating system and/or data. Changing the ATA configuration will result in data loss. If changing the ATA Configuration is necessary, take necessary steps to backup your information prior to proceeding.
This applies to:
| 
